Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
14
" The ZyWALL might force you to log out of your session if reauthentication
time, lease time, or idle timeout is reached. See Chapter 23 on page 171 for
more information about these settings.
1.2.1 Console Port
The default settings for the console port are as follows.
When you turn on your ZyWALL, it performs several internal tests as well as line
initialization. You can view the initialization information using the console port.
• Garbled text displays if your terminal emulation program’s speed is set lower than the
ZyWALL’s.
• No text displays if the speed is set higher than the ZyWALL’s.
• If changing your terminal emulation program’s speed does not get anything to display,
restart the ZyWALL.
• If restarting the ZyWALL does not get anything to display, contact your local customer
support.
Figure 1 Console Port Power-on Display
After the initialization, the login screen displays.
Table 1 Managing the ZyWALL: Console Port
SETTING VALUE
Speed 115200 bps
Data Bits 8
Parity None
Stop Bit 1
Flow Control Off
Main Processor : Intel Pentium(R) 4 2.80GHz(133x21.0)
Memory Testing : 346432K OK
Press DEL to enter SETUP60, ESC to skip memory test
To Next Page
Loading...
