Chapter 33 System Remote Management
ZyWALL (ZLD) CLI Reference Guide
222
33.9.4.1 Dial-in Management Command Examples
The following commands show you how to set up dial-in management with the following
parameters: active, port speed 57600, initial-string ATDT, and description “I am dial-in
management”.
33.10 Vantage CNM
Vantage CNM (Centralized Network Management) is a browser-based global management
solution that allows an administrator from any location to easily configure, manage, monitor
and troubleshoot ZyXEL devices located worldwide. See the Vantage CNM User's Guide for
details.
If you allow your ZyWALL to be managed by the Vantage CNM server, then you should not
do any configurations directly to the ZyWALL (using either the web configurator or
commands) without notifying the Vantage CNM administrator.
33.10.1 Vantage CNM Commands
The following table describes the commands available for dial-in management. You must use
the
configure terminal command to enter the configuration mode before you can use
these commands.
Router# configure terminal
Router(config)# dial-in
Router(config-dial-in)# activate
Router(config-dial-in)# port-speed 57600
Router(config-dial-in)# initial-string ATDT
Router(config-dial-in)# description I am dial-in management
Router(config-dial-in)# exit
Table 136 Command Summary: Vantage CNM
COMMAND DESCRIPTION
[no] cnm-agent manager url Sets up the URL of the Vantage server that the ZyWALL registers with.
Include the full HTTPS or HTTP URL. For example, https://1.2.3.4/vantage/
TR069.
[no] cnm-agent activate Turns management through Vantage CNM on or off.
cnm-agent keepalive
interval <10..90>
Sets the keepalive interval.
[no] cnm-agent periodic-
inform activate
Turns the periodic inform on or off.
cnm-agent periodic-inform
interval <10..86400>
Sets the periodic inform interval.
cnm-agent trigger-inform
[interval]
initiates a TR069 connection to the server. You can also specify the interval for
the inform messages.
[no] cnm-agent auth
activate
Enables or disables authentication of the server when using HTTPS.
show cnm-agent
configuration
Displays the Vantage CNM configuration.
To Next Page
Loading...
