ZyXEL Communications 1050 - ISP Accounts

ZyWALL (ZLD) CLI Reference Guide
201
CHAPTER 30
ISP Accounts
Use ISP accounts to manage Internet Service Provider (ISP) account information for PPPoE/
PPTP interfaces.
30.1 ISP Accounts Overview
An ISP account is a profile of settings for Internet access using PPPoE or PPTP.
30.2 ISP Account Commands Summary
The following table describes the values required for many ISP account commands. Other
values are discussed with the corresponding commands.
The following table lists the ISP account commands.
Table 120 Input Values for ISP Account Commands
LABEL DESCRIPTION
profile_name The name of the ISP account. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Table 121 account Commands
COMMAND DESCRIPTION
show account [pppoe profile_name | pptp
profile_name]
Displays information about the specified
account(s).
[no] account {pppoe | pptp} profile_name Creates a new ISP account with name
profile_name if necessary and enters sub-
command mode. The
no command deletes the
specified ISP account.
[no] user username Sets the username for the specified ISP account.
The
no command clears the username.
username: You can use alphanumeric,
underscores (_), dashes (-), and
/@$ characters,
and it can be up to 30 characters long.
[no] password password Sets the password for the specified ISP account.
The
no command clears the password.
password: You can use up to 63 printable ASCII
characters. Spaces are not allowed.
[no] authentication {chap-pap | chap | pap
| mschap | mschap-v2}
Sets the authentication for the specified ISP
account. The
no command sets the authentication
to chap-pap.