ZyWALL (ZLD) CLI Reference Guide
177
CHAPTER 24
Addresses
This chapter describes how to set up addresses and address groups for the ZyWALL.
24.1 Address Overview
Address objects can represent a single IP address or a range of IP addresses. Address groups
are composed of address objects and other address groups.
Address objects and address groups are used in dynamic routes, firewall rules, application
patrol, content filtering, and VPN connection policies. For example, addresses are used to
specify where content restrictions apply in content filtering. Please see the respective sections
for more information about how address objects and address groups are used in each one.
Address groups are composed of address objects and address groups. The sequence of
members in the address group is not important.
24.2 Address Commands Summary
The following table describes the values required for many address object and address group
commands. Other values are discussed with the corresponding commands.
The following sections list the address object and address group commands.
Table 103 Input Values for Address Commands
LABEL DESCRIPTION
object_name The name of the address. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
group_name The name of the address group. You may use 1-31 alphanumeric characters,
underscores(_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
To Next Page
Loading...
