Chapter 35 Logs
ZyWALL (ZLD) CLI Reference Guide
246
35.1.2 System Log Commands
This table lists the commands for the system log settings.
35.1.2.1 System Log Command Examples
The following command displays the current status of the system log.
Table 144 logging Commands: System Log Settings
COMMAND DESCRIPTION
show logging status system-log Displays the current settings for the system log.
logging system-log category module_name
{disable | level normal | level all}
Specifies what kind of information, if any, is logged
in the system log and debugging log for the
specified category.
[no] logging system-log suppression interval
<10..600>
Sets the log consolidation interval for the system
log. The
no command sets the interval to ten.
[no] logging system-log suppression Enables log consolidation in the system log. The
no command disables log consolidation in the
system log.
clear logging system-log buffer Clears the system log.
Router# configure terminal
Router(config)# show logging status system-log
512 events logged
suppression active : yes
suppression interval: 10
category settings :
content-filter : normal , forward-web-sites : no ,
blocked-web-sites : normal , user : normal ,
myZyXEL.com : normal , zysh : normal ,
idp : normal , app-patrol : normal ,
ike : normal , ipsec : normal ,
firewall : normal , sessions-limit : normal ,
policy-route : normal , built-in-service : normal ,
system : normal , connectivity-check: normal ,
device-ha : normal , routing-protocol : normal ,
nat : normal , pki : normal ,
interface : normal , interface-statistics: no ,
account : normal , port-grouping : normal ,
force-auth : normal , l2tp-over-ipsec : normal ,
anti-virus : normal , white-list : normal ,
black-list : normal , ssl-vpn : normal ,
cnm : normal , traffic-log : no ,
file-manage : normal , dial-in : normal ,
adp : normal , default : all ,
To Next Page
Loading...
