Chapter 33 System Remote Management
ZyWALL (ZLD) CLI Reference Guide
220
33.7.4 SNMP Commands Examples
The following command sets a service control rule that allowed the computers with the IP
addresses matching the specified address object to access the specified zone using SNMP
service.
The following command sets the password (secret) for read-write (
rw) access.
The following command sets the IP address of the host that receives the SNMP notifications to
172.23.15.84 and the password (sent with each trap) to qwerty.
33.8 ICMP Filter
The ip icmp-filter commands are obsolete. See Chapter 14 on page 93 to configure
firewall rules for ICMP traffic going to the ZyWALL to discard or reject ICMP packets
destined for the ZyWALL.
33.9 Dial-in Management
Connect an external serial modem to the DIAL BACKUP port (or AUX port depending on
your model) to provide a remote management connection in case the ZyWALL’s other WAN
connections are down. This is like an auxiliary interface, except it is used for management
connections coming into the ZyWALL instead of as a backup WAN connection.
33.9.1 AT Command Strings
For regular telephone lines, the default Dial string tells the modem that the line uses tone
dialing. ATDT is the command for a switch that requires tone dialing. If your switch requires
pulse dialing, change the string to ATDP.
Router# configure terminal
Router(config)# snmp-server rule 11 access-group Example zone WAN action
accept
Router# configure terminal
Router(config)# snmp-server community secret rw
Router# configure terminal
Router(config)# snmp-server host 172.23.15.84 qwerty
To Next Page
Loading...
