ZyXEL Communications 1050 - Configuring the Policy Route for L2 Tp Example

Chapter 17 L2TP VPN
ZyWALL (ZLD) CLI Reference Guide
116
• Enable the connection.
17.5.4 Configuring the Policy Route for L2TP Example
The following commands configure and display the policy route for the L2TP VPN
connection entry.
• Set the policy route’s Source Address to the address object that you want to allow the
remote users to access (LAN_SUBNET in this example).
• Set the Destination Address to the IP address pool that the ZyWALL assigns to the
remote users (L2TP_POOL in this example).
• Set the next hop to be the Default_L2TP_VPN_Connection tunnel.
Router(config)# l2tp-over-ipsec crypto Default_L2TP_VPN_Connection
Router(config)# l2tp-over-ipsec pool L2TP_POOL
Router(config)# l2tp-over-ipsec authentication default
Router(config)# l2tp-over-ipsec user L2TP-test
Router(config)# l2tp-over-ipsec activate
Router(config)# show l2tp-over-ipsec
L2TP over IPSec:
activate : yes
crypto : Default_L2TP_VPN_Connection
address pool : L2TP_POOL
authentication : default
user : L2TP-test
keepalive timer : 60
first dns server : aux 1st-dns
second dns server : aux 1st-dns
first wins server :
second wins server: