Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
18
1 If your computer is connected to the ZyWALL over the Internet, skip to the next step.
Make sure your computer IP address and the ZyWALL IP address are on the same
subnet.
2 In Windows, click Start (usually in the bottom left corner) and Run. Then type
telnet
and the ZyWALL’s IP address. For example, enter telnet 192.168.1.1 (the default
management IP address).
3 Click OK. A login screen displays. Enter the user name and password at the prompts.
" The default login username is admin and password is 1234. The username
and password are case-sensitive.
1.2.4 SSH (Secure SHell)
You can use an SSH client program to access the CLI. The following figure shows an example
using a text-based SSH client program. Refer to the documentation that comes with your SSH
program for information on using it.
" The default login username is admin and password is 1234. The username
and password are case-sensitive.
Figure 8 SSH Login Example
1.3 How to Find Commands in this Guide
You can simply look for the feature chapter to find commands. In addition, you can use one of
the following to look up specific commands.
C:\>ssh2 admin@192.168.1.1
Host key not found from database.
Key fingerprint:
xolor-takel-fipef-zevit-visom-gydog-vetan-bisol-lysob-cuvun-muxex
You can get a public key's fingerprint by running
% ssh-keygen -F publickey.pub
on the keyfile.
Are you sure you want to continue connecting (yes/no)? yes
Host key saved to C:/Documents and Settings/user/Application Data/SSH/
hostkeys/
ey_22_192.168.1.1.pub
host key for 192.168.1.1, accepted by user Tue Aug 09 2005 07:38:28
admin's password:
Authentication successful.
To Next Page
Loading...
