Chapter 35 Logs
ZyWALL (ZLD) CLI Reference Guide
249
35.1.4.1 E-mail Profile Command Examples
The following commands set up e-mail log 1.
35.1.5 Console Port Logging Commands
This table lists the commands for the console port settings.
Router# configure terminal
Router(config)# logging mail 1 address mail.zyxel.com.tw
Router(config)# logging mail 1 subject AAA
Router(config)# logging mail 1 authentication username lachang.li password
XXXXXX
Router(config)# logging mail 1 send-log-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 send-alerts-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 from lachang.li@zyxel.com.tw
Router(config)# logging mail 1 schedule weekly day mon hour 3 minute 3
Router(config)# logging mail 1
Table 148 logging Commands: Console Port Settings
COMMAND DESCRIPTION
show logging status console Displays the current settings for the console log.
(This log is not discussed above.)
[no] logging console Enables the console log. The
no command
disables the console log.
logging console category module_name level
{alert | crit | debug | emerg | error | info |
notice | warn}
Controls whether or not debugging information for
the specified priority is displayed in the console log,
if logging for this category is enabled.
[no] logging console category module_name Enables logging for the specified category in the
console log. The
no command disables logging.
To Next Page
Loading...
