ZyXEL Communications 1050 - Page 169

Chapter 22 Device HA
ZyWALL (ZLD) CLI Reference Guide
169
22.2.2 Synchronization Commands
This table lists the commands for synchronization. You can synchronize with other ZyWALL’s
of the same model that are running the same firmware version.
[no] description description Specifies the description for the specified VRRP
group. The
no command clears the description.
description: You can use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be up
to 60 characters long.
[no] activate Turns on the specified VRRP group. The
no
command turns off the VRRP group.
Table 93 device-ha Commands: VRRP Groups (continued)
COMMAND DESCRIPTION
Table 94 device-ha Commands: Synchronization
COMMAND DESCRIPTION
show device-ha sync Displays the current settings for synchronization.
show device-ha sync status Displays the current status of synchronization.
[no] device-ha sync from {hostname | ip} Specifies the fully-qualified domain name (FQDN)
or IP address of the ZyWALL router. Usually, this is
the IP address or FQDN of the virtual router. The
no command clears this field.
hostname: You may up to 254 alphanumeric
characters, dashes (-), or periods (.), but the first
character cannot be a period.
[no] device-ha sync port <1..65535> Specifies the port number to use to synchronize
with the specified ZyWALL router. The
no
command resets the port to 21.
[no] device-ha sync authentication password
password
Specifies the password to use when synchronizing.
Every router in the virtual router should use the
same password. The
no command resets the
password to “1234”.
password: You can use 4-63 alphanumeric
characters, underscores (_), dashes (-), and
#%^*={}:,.~ characters.
[no] device-ha sync auto Specifies whether or not to automatically
synchronize at regular intervals.
[no] device-ha sync interval <1..1440> Specifies the number of minutes between each
synchronization if the ZyWALL automatically
synchronizes with the specified ZyWALL router.
The
no command resets the interval to five
minutes.
[no] device-ha sync now Synchronize now.