ZyXEL Communications 1050 - Page 179

Chapter 24 Addresses
ZyWALL (ZLD) CLI Reference Guide
179
24.2.2.1 Address Group Command Examples
The following commands create three address objects A0, A1, and A2 and add A1 and A2 to
address group RD.
[no] object-group group_name Adds the specified address group (second
group_name) to the specified address group (first
group_name). The no command removes the
specified address group from the specified address
group.
[no] description description Sets the description to the specified value. The
no
command clears the description.
description: You can use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be up
to 60 characters long.
object-group address rename group_name
group_name
Renames the specified address group from the first
group_name to the second group_name.
Table 105 object-group Commands: Address Groups (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# address-object A0 192.168.1.1
Router(config)# address-object A1 192.168.1.2-192.168.2.20
Router(config)# address-object A2 192.168.3.0/24
Router(config)# object-group address RD
Router(group-address)# address-object A1
Router(group-address)# address-object A2
Router(group-address)# exit
Router(config)# show object-group address
Group name Reference
Description
===========================================================================
TW_TEAM 5
RD 0
Router(config)# show object-group address RD
Object/Group name Type Reference
===========================================================================
A1 Object 1
A2 Object 1