Chapter 34 File Manager
ZyWALL (ZLD) CLI Reference Guide
243
8 Set the transfer mode to binary (type bin).
9 Transfer the firmware file from your computer to the ZyWALL. Type put followed by
the path and name of the firmware file. This examples uses put e:\ftproot\ZLD
FW \1.01(XL.0)C0.db.
Figure 47 FTP Default System Database Transfer Command
10 Wait for the file transfer to complete.
Figure 48 FTP Default System Database Transfer Complete
11 The console session displays “done” after the default system database is recovered.
Figure 49 Default System Database Received and Recovery Complete
12 The username prompt displays after the ZyWALL starts up successfully. The default
system database recovery process is now complete and the ZyWALL IDP and anti-virus
features are ready to use again.
To Next Page
Loading...
