ZyXEL Communications 1050 - Interface Commands Summary

Chapter 5 Interfaces
ZyWALL (ZLD) CLI Reference Guide
49
* - You cannot set up a PPPoE/PPTP interface, virtual Ethernet interface or virtual VLAN interface if the
underlying interface is a member of a bridge. You also cannot add an Ethernet interface or VLAN
interface to a bridge if the member interface has a virtual interface or PPPoE/PPTP interface on top of it.
5.2 Interface Commands Summary
The following table identifies the values required for many of these commands. Other input
values are discussed with the corresponding commands.
The initial sections introduce commands that are supported by several types of interfaces. The
remaining sections then introduce the unique commands for each type of interface.
bridge interface Ethernet interface*
VLAN interface*
PPPoE/PPTP interface Ethernet interface*
VLAN interface*
bridge interface
virtual interface
(virtual Ethernet interface)
(virtual VLAN interface)
(virtual bridge interface)
Ethernet interface*
VLAN interface*
bridge interface
trunk Ethernet interface
VLAN interface
bridge interface
PPPoE/PPTP interface
auxiliary interface
Table 11 Relationships Between Different Types of Interfaces (continued)
INTERFACE
REQUIRED PORT /
INTERFACE
Table 12 Input Values for General Interface Commands
LABEL DESCRIPTION
interface_name The name of the interface.
Ethernet interface: gex, x = 1 - 5
virtual interface on top of Ethernet interface: gex:y, x = 1 - 5, y = 1 - 4
VLAN interface: vlanx, x = 0 - 31
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 31, y = 1 - 4
bridge interface: brx, x = 0 - 11
virtual interface on top of bridge interface: brx:y, x = 0 - 11, y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - 11
profile_name The name of the DHCP pool. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
domain_name Fully-qualified domain name. You may up to 254 alphanumeric characters,
dashes (-), or periods (.), but the first character cannot be a period.