Chapter 5 Interfaces
ZyWALL (ZLD) CLI Reference Guide
53
network IP/<1..32>
network ip mask
no network
Specifies the IP address and subnet mask of the
specified DHCP pool. The subnet mask can be
written in w.x.y.z format or in /<1..32> format.
Note: The DHCP pool must have the
same subnet as the interface to
which you plan to bind it.
The no command clears these fields.
[no] default-router ip Specifies the default gateway DHCP clients should
use. The
no command clears this field.
[no] domain-name domain_name Specifies the domain name assigned to DHCP
clients. The
no command clears this field.
[no] starting-address ip pool-size
<1..65535>
Sets the IP start address and maximum pool size
of the specified DHCP pool. The final pool size is
limited by the subnet mask.
Note: You must specify the network
number
first, and the start address
must be in the same subnet.
The no command clears the IP start address and
maximum pool size.
[no] first-dns-server {ip | interface_name
{1st-dns | 2nd-dns | 3rd-dns}
Sets the first DNS server to the specified IP
address or the specified interface’s first, second, or
third DNS server. The
no command resets the first
DNS server setting to its default value.
[no] second-dns-server {ip |
interface_name {1st-dns | 2nd-dns | 3rd-
dns}
Sets the second DNS server to the specified IP
address or the specified interface’s first, second, or
third DNS server. The
no command resets the
second DNS server setting to its default value.
[no] third-dns-server {ip | interface_name
{1st-dns | 2nd-dns | 3rd-dns}
Sets the third DNS server to the specified IP
address or the specified interface’s first, second, or
third DNS server. The
no command resets the
third DNS server setting to its default value.
[no] first-wins-server ip Specifies the first WINS server IP address to
assign to the remote users. The no command
removes the setting.
[no] second-wins-server ip Specifies the second WINS server IP address to
assign to the remote users. The no command
removes the setting.
[no] lease {<0..365> [<0..23> [<0..59>]] |
infinite}
Sets the lease time to the specified number of
days, hours, and minutes or makes the lease time
infinite. The
no command resets the first DNS
server setting to its default value.
interface interface_name Enters sub-command mode.
[no] ip dhcp-pool profile_name Binds the specified interface to the specified DHCP
pool. You have to remove any DHCP relays first.
The
no command removes the binding.
Table 15 interface Commands: DHCP Settings (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
