ZyXEL Communications 1050 - Page 61

Chapter 5 Interfaces
ZyWALL (ZLD) CLI Reference Guide
61
5.2.9.1 PPPoE/PPTP Interface Command Examples
The following commands show you how to configure PPPoE/PPTP interface ppp0 with the
following characteristics: base interface ge1, ISP account Hinet, local address 1.1.1.1, remote
address 2.2.2.2, MTU 1200, upstream bandwidth 345, downstream bandwidth 123, description
“I am ppp0”, and dialed only when used.
The following commands show you how to connect and disconnect ppp0.
interface interface_name Creates the specified interface if necessary and
enters sub-command mode.
[no] connectivity {nail-up | dial-on-
demand}
Specifies whether the specified PPPoE/PPTP
interface is always connected (nail-up) or
connected only when used (dial-on-demand). The
no command sets it to dial-on-demand.
[no] account profile_name Specifies the ISP account for the specified PPPoE/
PPTP interface. The
no command clears the ISP
account field.
[no] bind interface_name Specifies the base interface for the PPPoE/PPTP
interface. The
no command removes the base
interface.
[no] local-address ip Specifies a static IP address for the specified
PPPoE/PPTP interface. The
no command makes
the PPPoE/PPTP interface a DHCP client; the
other computer assigns the IP address.
[no] remote-address ip Specifies the IP address of the PPPoE/PPTP
server. If the PPPoE/PPTP server is not available
at this IP address, no connection is made. The no
command lets the ZyWALL get the IP address of
the PPPoE/PPTP server automatically when it
establishes the connection.
Table 26 interface Commands: PPPoE/PPTP Interfaces (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# interface ppp0
Router(config-if-ppp)# account Hinet
Router(config-if-ppp)# bind ge1
Router(config-if-ppp)# local-address 1.1.1.1
Router(config-if-ppp)# remote-address 2.2.2.2
Router(config-if-ppp)# mtu 1200
Router(config-if-ppp)# upstream 345
Router(config-if-ppp)# downstream 123
Router(config-if-ppp)# connectivity dial-on-demand
Router(config-if-ppp)# description I am ppp0
Router(config-if-ppp)# exit
Router# interface dial ppp0
Router# interface disconnect ppp0