Chapter 13 Rate Limit
GS1500-24P User’s Guide
109
Mask Enter the mask of the Source MAC Address.
Destination
IP Address
Enter a destination IP address in dotted decimal notation.
Mask Enter the subnet mask of the Destination IP Address.
Source IP
Address
Enter a source IP address in dotted decimal notation.
Mask Enter the subnet mask of the Source IP Address.
VLAN ID Type the VLAN ID for which this rule will apply. Specify 0 to ignore this field.
TCP/UDP
Destination
Port
Type the destination port number to which the rule should be applied. Type
0 to ignore this field. See Appendix B on page 171 for a list of common
services.
TCP/UDP
Source Port
Type the source port number to which the rule should be applied. Type 0 to
ignore this field. See Appendix B on page 171 for a list of common services.
Ether Type Specify an Ethernet type in hexadecimal value.
Source Port Specify a source port, if any.
Rate Limit Configure the desired bandwidth available to the traffic flow. Traffic that
exceeds the maximum bandwidth allocated (in cases where the network is
congested) is dropped.
Specify the bandwidth in kilobit per second (Kbps). Enter a number
between 0 and 1048560. The number must be a multiple of 16.
Add Click Add to save the rate limit policy to the Switch.
Table 35 Configuration > Rate Limit Add/Modify (continued)
LABEL DESCRIPTION
To Next Page
Loading...
