Chapter 7 Link Aggregation
GS1500-24P User’s Guide
65
2 Adding ports to the trunk group - Click Configuration > Link Aggregation >
Trunk Group Setting. In this screen select trunk Group ID Trunk1, select the
type Static and then highlight ports 2 to 5. To highlight multiple ports hold down
[CTRL] while clicking on the ports. Click Add / Modify when you are done.
Figure 29 Trunking Example - Configuration Screen
3 Configuring trunk distribution algorithm - Click Configuration > Link
Aggregation > Trunk Distribution Algorithm Setting. In this screen select
trunk Group ID Trunk1 and then select the traffic distribution algorithm used by
this group. Click Apply when you are done
Figure 30 Trunking Example - Configuration Screen 2
Your trunk group 1 (T1) configuration is now complete.
To Next Page
Loading...
