ZyXEL Communications GS1500-24P - Page 94

Chapter 11 Mirroring
GS1500-24P User’s Guide
94
Note: Before configuring a policy-based mirroring rule, you must first assign one of
the mirror sets to a mirroring port on the port-based mirroring screen. See
Section 11.3 on page 92 for more details.
Figure 45 Configuration > Mirroring > Policy-based MIrroring > Add/Modify
The following table describes the related labels in this screen.
Table 28 Configuration > Mirroring > Policy-based MIrroring > Add/Modify
LABEL DESCRIPTION
Name Enter a descriptive name for the policy.
Destination
IP Address
Enter a destination IP address in dotted decimal notation.
Mask Enter the subnet mask of the Destination IP Address.
Source IP
Address
Enter a source IP address in dotted decimal notation.
Mask Enter the subnet mask of the Source IP Address.
TCP/UDP
Destination
Port
Type the source port number to which the policy should be applied. Type 0
to ignore this field. See Appendix B on page 171 for a list of common
services.
TCP/UDP
Source Port
Type the destination port number to which the rule should be applied. Type
0 to ignore this field. See Appendix B on page 171 for a list of common
services.
Mirror Set Select the mirror set index number 1 or 2. This is used in conjunction with
the port-based mirroring screen. For example, if mirror set 1 is using port 5
as a mirroring port then port 5 will be the mirroring port for this policy if
mirror set 1 is selected on this screen.
You cannot use this field if you have not assigned a mirroring port to a
mirror set index on the port-based mirroring screen.
Add Click Add to save the policy to the Switch.