Chapter 2 The Web Configurator
LTE3202-M430 User’s Guide
19
WLAN station
status
Use this screen to view the wireless stations that are currently
associated to the LTE3202-M430’s 2.4GHz wireless LAN.
LTE modem status Use this screen to view the detailed information about the LTE module,
cellular interface, and SIM card. You can also view the LTE connection
status.
Configuration
WAN network Cellular Network Use this screen to specify the type of the mobile network to which the
LTE3202-M430 is connected, and how you want the LTE3202-M430 to
connect to an available mobile network.
PIN Settings Use this screen to enable PIN code authentication and enter the PIN
code.
APN
Configuration
Use this screen to configure user-defined connection profiles.
Network
Selection
Use this screen to view available Public Land Mobile Networks (PLMNs)
and select a preferred network.
Data Usage /
Statistics
Use this screen to specify limiting amount of package data consumed
and view its statistics.
Operating Mode Use this screen to select whether the LTE3202-M430 operates in router
or bridge mode.
Antenna
Selection
Use this screen to specify which antennas the LTE3202-M430 uses for
signal transmission.
LAN network LAN IP Use this screen to configure LAN IP address and subnet mask.
DHCP Server Use this screen to enable the LTE5366’s DHCP server, and assign IP
addresses to specific individual computers based on their MAC
addresses and to have DNS servers assigned by the DHCP server.
DNS Settings Use this screen to configure the DNS servers.
WLAN WiFi Settings Use this screen to enable the wireless LAN and configure wireless LAN
and wireless security settings.
MAC Filter Use the MAC filter screen to allow or deny wireless stations based on
their MAC addresses from connecting to the LTE3202-M430.
WPS Use this screen to use WPS to connect to a wireless device.
Firewall DOS protection Use this screen to enable/disable DoS protection.
ICMP Protection Use this screen to enable/disable PING requests in the LTE3202-M430
interfaces.
ARP Protection Use this screen to enable Address Resolution Protocol (ARP)
protection.
URL Filter Use this screen to configure URL firewall rules.
IPv4 Port Filter Use this screen to create IPv4 firewall rules.
IPv6 Port Filter Use this screen to create IPv6 firewall rules.
NAT IP/Port
Forwarding
Use this screen to configure servers behind the LTE3202-M430 and
forward incoming service requests to the server(s) on your local
network.
DMZ Use this screen to set the IP address of your network DMZ (if you have
one) for the LTE3202-M430.
ALG Use this screen to enable or disable SIP (VoIP) ALG (Application Layer
Gateway) in the LTE3202-M430.
Pass through Use this screen to enable/disable the ALGs (Application Layer
Gateway) in the LTE3202-M430.
Table 4 Navigation Panel
MENU SUB-MENU DESCRIPTION
To Next Page
Loading...
