Chapter 14 System
LTE3202-M430 User’s Guide
90
The following table describes the labels in this screen.
14.3 The User Account Screen
This screen allows you to set the domain name and change the LTE3202-M430’s system password. It is
strongly recommended that you change your LTE3202-M430's system password. To access this screen,
click Maintenance > User Account.
See Section 2.2 on page 14 for more information about login accounts.
Figure 67 Maintenance > User Account
The following table describes the labels in this screen.
Table 46 System > System Information
LABEL DESCRIPTION
General Information
System name System name is a unique name to identify the LTE3202-M430 in an Ethernet network.
Domain name Enter the domain name you want to give to the LTE3202-M430.
Inactivity timer Type how many minutes a management session can be left idle before the session times out.
The default is 300 seconds. After it times out you have to log in with your password again. Very
long idle timeouts may have security risks. A value of "0" means a management session never
times out, no matter how long it has been left idle (not recommended).
S/N This displays the serial number of the LTE3202-M430.
FW Version This displays the current firmware version of the LTE3202-M430.
Apply Click this button to save your changes back to the LTE3202-M430.
Reset Click Reset to reload the previous configuration for this screen.
Table 47 System > User Account
LABEL DESCRIPTION
User Settings
Username Enter your username of the system account.
Password Type your new system password. Note that as you type a password, the screen displays as
dot (.) for each character you type.
Confirm Password Type the new password again in this field.
Apply Click Apply to save your changes back to the LTE3202-M430.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
