Chapter 7 LAN
LTE3202-M430 User’s Guide
43
The following table describes the labels in this screen.
7.5 The DHCP Server Screen
The LTE3202-M430 has built-in DHCP server capability that assigns IP addresses to systems that support
DHCP client capability. Use this screen to enable the DHCP server. To access this screen, click
Configuration > LAN network > DHCP Server.
Figure 29 Configuration > LAN network > DHCP Server
The following table describes the labels in this screen.
Table 18 Router > LAN IP
LABEL DESCRIPTION
IP Address This shows the default LAN IP address.
Enter the new IP address for the LTE3202-M430’s LAN interface if you want to change it.
Subnet Mask This shows the default subnet mask.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Apply Click Apply to save your changes back to the LTE3202-M430.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 19 Router > DHCP Server
LABEL DESCRIPTION
DHCP Settings
DHCP Select to Enable or Disable the DHCP server on the LTE3202-M430.
To Next Page
Loading...
