ZyXEL Communications LTE3202-M430 - The Packet Statistics Screen

Chapter 5 Monitor
LTE3202-M430 User’s Guide
30
The following screen describes the labels on this screen.
5.6 The Packet Statistics Screen
Click Monitor > Packet Statistics or the Packet Statistics (Details...) hyperlink in the Status screen. Read
only information here includes port status, packet specific statistics and the “system up time”.
Figure 14 Monitor > Packet Statistics
The following table describes the labels on this screen.
Table 9 Monitor > ARP Table
LABEL DESCRIPTION
No. This is the index number of the entry.
IP Address This is the learned IPv4 or IPv6 IP address of a device connected to a port.
MAC Address This is the MAC address of the device with the listed IP address.
Device
This is the type of interface used by the device.
• LAN indicates a LAN interface where 0 represents LAN1 or LAN2.
• WLAN indicates a connection via WiFi network.
State This column shows the current status of the connection.
Table 10 Monitor > Packet Statistics
LABEL DESCRIPTION
No. This is the index number of the entry.
Port This is the LTE3202-M430’s interface type.
Status For the LAN ports, this displays the port speed and duplex setting or Down when the
line is disconnected.
For the WAN port, it displays Up when the mobile data connection is up, Connecting
when the LTE3202-M430 is trying to bring the mobile data connection up, and
displays Down when the 3G/4G connection is down or not activated.
For the WLAN, it displays the maximum transmission rate when the WLAN is enabled
and Down when the WLAN is disabled.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Collisions This is the number of collisions on this port.
Tx B/s This displays the transmission speed in bytes per second on this port.
Rx B/x This displays the reception speed in bytes per second on this port.
Up Time This is the total time the LTE3202-M430 has been for each session.