ZyXEL Communications LTE3202-M430 - 8.4 WPS Screen

Chapter 8 WLAN
LTE3202-M430 User’s Guide
51
The following table describes the labels in this screen.
8.4 WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your LTE3202-M430.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See Section 8.5.5.3 on page 59 for more information about WPS.
Click Configuration > WLAN > WPS. The following screen displays.
Figure 34 Configuration > WLAN > WPS: PBC Method
Table 22 Configuration > WLAN> MAC Filter
LABEL DESCRIPTION
MAC Filter
Mode
Select the checkbox to prohibit devices with the MAC addresses you configured.
MAC Filter
method
Select Whitelist description to permit access to the LTE3202-M430, MAC addresses not listed will
be denied access to the LTE3202-M430.
Select Blacklist description to block access to the LTE3202-M430, MAC addresses not listed will
be allowed to access the LTE3202-M430.
Blacklist/
Whitelist
This displays how many entries you have in the Whitelist description/Blacklist description
summary tables.
Add New Click Add New to create a MAC Filtering rule.
Delete All Click Delete All to remove all MAC Filtering rules.
MAC address This field displays the MAC addresses of the wireless devices that are allowed or denied access
to the LTE3202-M430.
Click Add New or Edit to enter or change the MAC address of the wireless devices that are
allowed or denied access to the LTE3202-M430 in this field. Enter the MAC addresses in a valid
MAC address format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Description This field displays the name of the MAC address entry.
Click Add New or Edit to enter a descriptive name to identify the MAC address entry. You can
enter up to 20 printable ASCII characters. Spaces are allowed.
Action Click Edit to go to the screen where you can edit the rule.
Click Delete to remove the MAC address entry.
Apply Click Apply to save your changes back to the LTE3202-M430.
Cancel Click Cancel to reload the previous configuration for this screen.