Chapter 5 Monitor
LTE3202-M430 User’s Guide
28
Figure 11 Monitor > Log
The following table describes the labels on this screen.
5.4 The DHCP Table Screen
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients to obtain
TCP/IP configuration at start-up from a server. You can configure the LTE3202-M430’s LAN as a DHCP
server or disable it. When configured as a server, the LTE3202-M430 provides the TCP/IP configuration for
the clients. If DHCP service is disabled, you must have another DHCP server on that network, or else the
computer must be manually configured.
Table 7 Monitor > Log
LABEL DESCRIPTION
Enable Log Select this to enable Log
Log Level
Enable Remote Log Select this to send the logs to a remote host.
Remote Log Host Enter the remote host’s IP address.
Remote Log Port Enter the port used for this service.
Apply Click Apply to save your changes back to the LTE3202-M430.
Cancel Click Cancel to reload the previous configuration for this screen.
Refresh Click Refresh to renew the Log screen.
To Next Page
Loading...
