Chapter 6 WAN Network
LTE3202-M430 User’s Guide
40
Figure 23 LTE3202-M430 in Router Mode
• Bridge Mode: Select this mode if you already have a router in your network, and you don’t want to
reconfigure your network. If you don’t have a router, you’ll need multiple IP addresses from your ISP
for your clients.
Use this screen to change the LTE3202-M430’s operating mode. Click Configuration > WAN network >
Operation Mode to open the following screen.
Figure 24 Configuration > WAN network > Operation Mode
6.8 The Antenna Selection Screen
Click Configuration > WAN network > Antenna Selection to open the following screen.
The LTE3202-M430 has two internal antennas, you can also install two external antennas to improve your
wireless WAN signal strength. The LTE3202-M430 uses the internal antennas by default. If you installed
external antennas, select External for the LTE3202-M430 to use these to detect the WAN network. Click
Apply to save your settings, otherwise select Cancel.
Figure 25 Configuration > WAN network > Antenna Selection
To Next Page
Loading...
