ZyXEL Communications LTE3202-M430 - The Telnet Screen

Chapter 12 Remote Management
LTE3202-M430 User’s Guide
81
12.4 The Telnet Screen
You can use Telnet to access the LTE3202-M430’s command line interface. Specify which interfaces
allow Telnet access.
Click Configuration > Remote Management > Telnet to open the following screen.
Figure 57 Configuration > Remote Management > Telnet
The following table describes the labels on this screen.
ACS Username Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
Enable Periodic Inform Select the check box for the LTE3202-M430 to send periodic inform via TR-069 on the
WAN.
Periodic Inform Interval Enter the time interval (in seconds) at which the LTE3202-M430 sends information to
the auto-configuration server.
Connection Request Port Enter the port number for TR-069 connection requests.
Connection Request
Username
Enter the connection request user name.
When the ACS makes a connection request to the LTE3202-M430, this user name is
used to authenticate the ACS.
Connection Request
Password
Enter the connection request password.
When the ACS makes a connection request to the LTE3202-M430, this password is
used to authenticate the ACS.
Apply Click Apply to save your changes back to the LTE3202-M430.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 38 Configuration > Remote Management > TR069
LABEL DESCRIPTION
Table 39 Configuration > Remote Management > Telnet
LABEL DESCRIPTION
Telnet
LAN Select this check box to enable devices in the LTE3202-M430’s LAN network to
access the LTE3202-M430 using Telnet.
WAN port Select this check box to enable devices in the LTE3202-M430’s WAN network to
access the LTE3202-M430 using Telnet.
Specify the service port number for accessing the LTE3202-M430.