ZyXEL Communications LTE3202-M430 - Page 33

Chapter 5 Monitor
LTE3202-M430 User’s Guide
33
LAC This displays the 2-octet Location Area Code (LAC), which is used to identify a
location area within a PLMN.
TAC This displays the Tracking Area Code (TAC), which is to identify a tracking area within
a PLMN.
Cell ID This displays the ID of a cell at the physical layer.
Service Type This displays the type of the mobile network to which the LTE3202-M430 is
connecting.
Operation Band This displays the network type and the frequency band used by the mobile network
to which the LTE3202-M430 is connecting.
RSSI This displays the received signal strength indicator (RSSI), that is, the received signal
strength in dBm.
Register Status This displays the packet switched network registration status.
Ecio This displays the ratio (in dB) of the received energy per chip and the interference
level.
CS Attached Status This displays the Circuit Switched network registration status.
PS Attached Status This displays the Packet switched Domain Attachment status.
Roaming Status This displays whether the LTE3202-M430 is connected to another service provider’s
mobile network using roaming.
IMSI This displays the International Mobile Subscriber Identity (IMSI) stored in the SIM
(Subscriber Identity Module) card. The SIM card is installed in a mobile device and
used for authenticating a customer to the carrier network. IMSI is a unique 15-digit
number used to identify a user on a network.
SMSC This displays the number for Short Message Service Center (SMSC), which stores,
forwards and delivers SMS text message.
MSISDN This displays the MSISDN (Mobile Subscriber ISDN) number, a phone number assigned
to a mobile subscriber to call a mobile device.
RSRP This displays the Reference Signal Receive Power (RSRP), which is the average
received power of all Resource Elements (RE) that carry cell-specific Reference
Signals (RS) within the specified bandwidth.
RSRQ This displays the Reference Signal Received Quality (RSRQ), which is the ratio of RSRP
to the E-UTRA carrier RSSI and indicates the quality of the received reference signal.
SINR This displays the Signal to Interference plus Noise Ratio (SINR). A negative value
means more noise than signal.
PLMN This displays the Public Land Mobile Network (PLMN) code of the mobile network.
MIMO This displays the MIMO (Multi-input Multi-output) technology supported by the
LTE3202-M430, such as 1T2R (1 Transmit and 2 Receive paths/antennas) or TM1-TM4
(Transmission Mode 4).
Support Band List This displays the frequency bands that are supported by the LTE3202-M430.
Table 12 Monitor > LTE modem status
LABEL DESCRIPTION