ZyXEL Communications LTE7410 - The Log Screen

Chapter 15 System Monitor
LTE7410 User’s Guide
115
15.3 The Log Screen
Click System Monitor > Log to open the Log screen. Use the Log screen to see the system logs
for the categories that you select in the upper left drop-down list box.
Figure 78 System Monitor > Log
The following table describes the fields in this screen.
IMEI
This displays the LTE Device’s International Mobile Equipment Identity number (IMEI). An
IMEI is a unique ID used to identify a mobile device.
SIM Card
Status
This displays the SIM card status.
LTE Status
Status This displays Up if there is an LTE connection, otherwise, it displays Down.
RSSI(dBm)
This displays the Received Signal Strength Indication (RSSI) of the LTE connection.
RSRP(dBm) This displays the Reference Signal Received Power (RSRP) of the LTE connection.
SINR(dB) This displays the signal-to-interference-plus-noise (SINR) ratio.
Service
Provider
This displays the service provider’s name of the connected LTE network.
Frequency
Band
These bands are divided into numerous channels. This allows a variety of networks to exist
in the same place without interfering with one another. When you create a network, you
must select a channel to use. Since the available unlicensed spectrum varies from one
country to another, the number of available channels also varies.
APN
Access Point Name (APN) is a unique string which indicates an LTE network. An APN is
required for LTE stations to enter the LTE network and then the Internet.
Connection
Uptime
This displays how long the LTE connection has been available since it was last established
successfully.
Table 47 System Monitor > LTE Status (continued)
LABEL DESCRIPTION
Table 48 System Monitor > Log
LABEL DESCRIPTION
Level Select a severity level from the drop-down list box. This filters search results according to
the severity level you have selected. When you select a severity, the LTE Device searches
through all logs of that severity or higher.
Refresh Click this to renew the log screen.