Chapter 12 L2TP VPN
LTE7410 User’s Guide
88
12.3 The Edit L2TP Tunnel Screen
Use this screen to modify a L2TP VPN tunnel. Click Security > L2TP VPN and then the Edit icon
to open the following screen.
Figure 65 Security > L2TP VPN > Modify
The following table describes the labels in this screen.
Table 35 Security > L2TP VPN > Modify
LABEL DESCRIPTION
Active Click this to activate the L2TP VPN.
Default Route Click this to activate the default route.
L2TP Tunnel
Name
This shows the IP address that the LTE Device assigned for the remote user's computer to
use within the L2TP VPN tunnel.
L2TP Protocol
Layer
Select which OSI layer (Layer2 or Layer3) protocol the L2TP tunnels over a network. Use
Layer3 L2TP to have the LTE Device tunnel OSI layer 3 protocol over a network and
Layer2 L2TP for OSI layer 2 protocol (BCP tunnel).
Secure Gateway
Address
If you configure this field to 0.0.0.0 or leave it blank, the LTE Device will use the address
in the Secure Gateway Address field (refer to the Secure Gateway Address field
description).
Username The remote user must log into the LTE Device to use the L2TP VPN tunnel. This shows a
user or user group that can use the L2TP VPN tunnel.
Password Enter the password for the user.
Auth Select the protocol (EAP, MSCHAPv1 or MSCHAPv2) the LTE Device uses for user
authentication.
OK Click this button to save your settings back to the LTE Device.
Back Click this button to return to the previous screen without saving any changes.
To Next Page
Loading...
