Chapter 23 Remote Management
LTE7410 User’s Guide
133
•Use the SSH screen (Section 23.5 on page 136) to configure through which interfaces and from
which IP addresses users can use SSH to manage the LTE Device.
23.1.2 What You Need to Know About Remote Management
Remote Management Limitations
• Remote management does not work when:
• You have not enabled that service on the interface in the corresponding remote management
screen.
• You have disabled that service in one of the remote management screens.
• The IP address in the Secured Client IP Address field does not match the client IP address. If
it does not match, the LTE Device will disconnect the session immediately.
• There is a firewall rule that blocks it.
Remote Management and NAT
When NAT is enabled:
• Use the LTE Device’s WAN IP address when configuring from the WAN.
• Use the LTE Device’s LAN IP address when configuring from the LAN.
23.2 The WWW Screen
Use this screen to specify how to connect to the LTE Device from a web browser, such as Internet
Explorer.
23.2.1 Configuring the WWW Screen
Click Maintenance > Remote MGMT to display the WWW screen.
To Next Page
Loading...
