ZyXEL Communications LTE7410 - SIM Screen

Chapter 4 Broadband
LTE7410 User’s Guide
27
4.3 SIM Screen
Use the SIM screen to enter the PIN of your SIM card.
Entering the wrong PIN code 3 times locks the SIM card after which you
need a PUK from the service provider to unlock it.
Click Network Setting > Broadband > SIM. The following screen opens.
Authentication
Type
When you select Authentication, specify the type of authentication the LTE Device accepts
for the LTE connection. The Device supports PAP (Password Authentication Protocol) and
CHAP (Challenge Handshake Authentication Protocol). CHAP provides more security than
PAP; however, PAP has higher availability on more platforms.
Username Enter the user name provided by your LTE service provider.
Password Enter the password provided by your LTE service provider.
IPv4/IPv6 Dual
Stack
Select IPv4 if you want the LTE Device to run IPv4 only.
Select IPv6/IPv4 to allow the LTE Device to run IPv4 and IPv6 at the same time.
Select IPv6 if you want the LTE Device to run IPv6 only.
MTU
MTU
The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed on an
interface or connection. Enter the MTU for this WAN interface in this field.
Routing Feature
NAT Enable Select this to activate NAT on this WAN interface.
Default
Gateway
Select this option to have the LTE Device use the WAN interface of this connection as the
system default gateway.
Bridge Mode Bridge mode allows a LAN computer on the local network of the LTE Device to have access
to web services using the public IP address. When bridge mode is configured, all traffic is
forwarded to the computer and will not go through NAT.
Select the Bridge Mode for this LTE connection.
Select None to disable this feature.
Select Dynamic to allow the first connected LAN computer to have access to web services
using the public IP address.
Select Fixed to set the bridge mode to pass traffic through to a fixed MAC address. This
allows the LAN computer with the MAC address specified in the Passthrough to fixed
MAC field to have access to web services using the public IP address.
OK Click this to save your changes.
Back Click this to exit this screen without saving.
Table 3 Network Setting > Broadband > LTE Interface Edit (continued)
LABEL DESCRIPTION