Chapter 23 Remote Management
LTE7410 User’s Guide
137
Figure 96 Maintenance > Remote MGMT > SSH
The following table describes the labels in this screen.
23.5.1 SSH Example
This section shows an example using a graphical interface SSH client program to remotely access
the ZyXEL device. The configuration and connection steps are similar for most SSH client programs.
Refer to your SSH client program user’s guide.
1 Enter the IP address and port number. Select SSH.
Table 63 Maintenance > Remote MGMT > SSH
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the LTE Device. If the number is
grayed out, it is not editable.
Server Access Select the interfaces through which a computer may access the LTE Device using this
service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the LTE
Device using this service.
Select All to allow any computer to access the LTE Device using this service.
Choose Range to just allow the computers with an IP address in the range that you
specify to access the LTE Device using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
