ZyXEL Communications LTE7410 - Add;Edit Static Lease

Chapter 6 Static Route
LTE7410 User’s Guide
51
Figure 35 Network Setting > Routing > Static Route
The following table describes the labels in this screen.
6.2.1 Add/Edit Static Lease
Click Add New Static Lease in the Static Routing screen, the following screen appears. Use this
screen to configure the required information for a static route.
Figure 36 Routing: Add New Static Lease
Table 11 Network Setting > Routing > Static Route
LABEL DESCRIPTION
Add New Static
Lease
Click this to set up a new static route on the LTE Device.
# This is the number of an individual static route.
Active This specifies whether the static route is on or off.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Interface This is the WAN interface through which the traffic is routed.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Metric This is the “cost” of transmission for routing purposes.
Modify Click the Edit icon to go to the screen where you can set up a static route on the LTE
Device.
Click the Delete icon to remove a static route from the LTE Device.