LTE7410 User’s Guide
132
CHAPTER 23
Remote Management
23.1 Overview
Remote management allows you to determine which services/protocols can access which LTE
Device interface (if any) from which computers.
The following figure shows remote management of the LTE Device coming in from the WAN.
Figure 92 Remote Management From the WAN
Note: When you configure remote management to allow management from the WAN, you
still need to configure a IP filter rule to allow access.
You may manage your LTE Device from a remote location via:
• Internet (WAN only)
•LAN only
•LAN and WAN
• None (Disable)
To disable remote management of a service, select Disable in the corresponding Service Access
field.
23.1.1 What You Can Do in the Remote Management Screens
•Use the WWW screen (Section 23.2 on page 133) to configure through which interfaces and
from which IP addresses users can use HTTP to manage the LTE Device.
•Use the Telnet screen (Section 23.3 on page 135) to configure through which interfaces and
from which IP addresses users can use Telnet to manage the LTE Device.
•Use the ICMP screen (Section 23.4 on page 135) to set whether or not your LTE Device will
respond to pings and probes for services that you have not made available.
To Next Page
Loading...
