Chapter 23 Remote Management
LTE7410 User’s Guide
135
23.3 Telnet Screen
You can use Telnet to access the Device’s command line interface. Specify which interfaces allow
Telnet access and from which IP address the access can come.
Click Maintenance > Remote MGMT > Telnet tab to display the screen as shown.
Figure 94 Maintenance > Remote MGMT > Telnet
The following table describes the labels in this screen.
23.4 ICMP Screen
To change your LTE Device’s security settings, click Maintenance > Remote MGMT > ICMP. The
screen appears as shown.
Table 61 Maintenance > Remote MGMT > Telnet
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the LTE Device. If the number is
grayed out, it is not editable.
Server Access Select the interfaces through which a computer may access the LTE Device using this
service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the LTE
Device using this service.
Select All to allow any computer to access the LTE Device using this service.
Choose Range to just allow the computers with an IP address in the range that you
specify to access the LTE Device using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
