ZyXEL Communications LTE7410 - Page 122

Chapter 17 TR-069 Client
LTE7410 User’s Guide
122
The following table describes the fields in this screen.
Table 54 Maintenance > TR-069 Client
LABEL DESCRIPTION
CWMP Select Enable to allow the LTE Device to be managed by a management server. Otherwise,
select Disable to not allow the LTE Device to be managed by a management server.
ACS URL Enter the URL or IP address of the auto-configuration server.
Check with your ISP/network administrator if you are not sure of this information.
ACS User Name Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
Connection
Request Path
Type the IP address or domain name of the LTE Device. The management server
uses this path to verify the LTE Device.
Connection
Request Port
The default port for access to the LTE Device from the management server is the HTTP port,
port 80. If you change it, make sure it does not conflict with another port on your network
and it is recommended to use a port number above 1024 (not a commonly used port). The
management server should use this port to connect to the LTE Device. You may need to alter
your NAT port forwarding rules if they were already configured.
Connection
Request User
Name
Enter the connection request user name.
When the ACS makes a connection request to the LTE Device, this user name is used to
authenticate the ACS.
Connection
Request
Password
Enter the connection request password.
When the ACS makes a connection request to the LTE Device, this password is used to
authenticate the ACS.
Inform Select Enable for the LTE Device to send periodic inform via TR-069 on the WAN. Otherwise,
select Disable.
Inform Interval Enter the time interval (in seconds) at which the LTE Device sends information to the auto-
configuration server.
Bound
Interface Name
Select the WAN interface the ACS is bound to.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore the screen’s last saved settings.