ZyXEL Communications LTE7410 - Page 22

Chapter 3 Connection Status and System Info
LTE7410 User’s Guide
22
LAN Information
IP Address This field displays the current IP address of the LTE Device in the LAN.
IP Subnet Mask This field displays the current subnet mask in the LAN.
DHCP This field displays what DHCP services the LTE Device is providing to the LAN:
Server - The LTE Device is a DHCP server in the LAN. It assigns IP addresses to
other computers in the LAN.
None - The LTE Device is not providing any DHCP services to the LAN.
IPv6 Address This is the current IPv6 address of the LTE Device in the LAN.
Link-local IPv6
Address
This is the current LAN IPv6 link-local address of the LTE Device.
IPv6 Prefix This is the current IPv6 prefix length in the LAN.
Preferred/Valid Time
(sec)
This is the preferred lifetime and valid lifetime in the LAN.
DHCPv6 This field displays what DHCPv6 services the LTE Device is providing to the LAN:
Server - The Device is a DHCPv6 server in the LAN. It assigns IP addresses to
other computers in the LAN.
None - The LTE Device is not providing any DHCPv6 services to the LAN.
Radvd Mode This shows the status of RADVD (Router Advertisement Daemon).
IPv6 LAN DNS1/
DNS2
This is the first/second DNS server IPv6 address the LTE Device passes to the DHCP
clients.
Security
Firewall This shows whether or not the firewall is enabled (on).
LTE Status
LTE Status This displays UP for an LTE connection. Down displays when the LTE Device does
not have a cellular connection.
SIM Card Status This displays the SIM card status:
PIN DISABLE - the SIM card has no PIN code security.
PIN REQUIRED - the SIM card has PIN code security, but you did not enter the
PIN code yet.
PIN VERIFIED - the SIM card has PIN code security, and you entered the correct
PIN code.
PIN locked - you entered an incorrect PIN code too many times, so the SIM card
has been locked; call the ISP for a PUK (Pin Unlock Key) to unlock the SIM card.
SIM ERROR - the LTE Device does not detect that there is a SIM card inserted.
RSSI (dBm) This displays the strength of the LTE connection that the LTE Device has with the
base station which is also known as eNodeB or eNB.
RSRP (dBm) This displays the LTE RSRP (Reference Signal Received Power).
SINR (dB) This displays the Signal to Interference plus Noise Ratio in dB.
Service Provider This displays the service provider’s name of the connected LTE network.
Frequency Band This displays the frequency band of the cellular connection. LTE displays for an LTE
connection.
Connection Uptime This displays how long the LTE connection has been available since it was last
established successfully.
LTE Firmware
Version
This displays the version of the firmware on the LTE module.
Table 1 System Info Screen (continued)
LABEL DESCRIPTION