Chapter 14 VoIP
LTE7410 User’s Guide
98
Min-SE Enter the minimum number of seconds the LTE Device lets a SIP session remain idle
(without traffic) before it automatically disconnects the session. When two SIP devices
start a SIP session, they must agree on an expiration time for idle sessions. This field is
the shortest expiration time that the LTE Device accepts.
Dialing interval selection
Dialing interval
selection
Enter the number of seconds the LTE Device should wait after you stop dialing numbers
before it makes the phone call. The value depends on how quickly you dial phone
numbers.
Phone Key Config
Use this section to customize the phone keypad combinations you use to access certain features on the LTE
Device.
Caller Display Call
This code is used to display the caller ID for outgoing calls.
Caller Hidden Call This code is used to hide the caller ID for outgoing calls.
One Shot Caller
Display Call
This code is used to display the caller ID only for the phone call your are going to make.
One Shot Caller
Hidden Call
This code is used to hide the caller ID only for the phone call your are going to make.
Call Waiting
Enable
This code is used to turn the call waiting feature on. With call waiting, you hear a special
beep notifying you of another incoming call while you have a call. It allows you to place
the first incoming call on hold and answer the second call so that you won’t miss any
important calls.
Call Waiting
Disable
This code is used to turn the call waiting feature off.
One Shot Call
Waiting Enable
This code is used to enable call waiting only for the phone call your are going to make.
See the description for the Call Waiting Enable field for more information.
One Shot Call
Waiting Disable
This code is used to disable one shot call waiting.
Call Transfer
This code is used to enable call transfer that allows you to transfer an incoming call (that
you have answered) to another phone.
Unconditional Call
Forward Enable
This code is used to enable unconditional call forwarding. Incoming calls are always
forwarded to a specified number without any condition.
Unconditional Call
Forward Disable
This code is used to disable unconditional call forwarding.
No Answer Call
Forward Enable
This code is used to enable call forwarding when there is no answer at a SIP number (no
one picked up the connected phone that uses the SIP number).
No Answer Call
Forward Disable
This code is used to disable call forwarding when there is no answer at a SIP number (no
one picked up the connected phone that uses the SIP number).
Call Forward
When Busy
Enable
This code is used to enable call forwarding when the phone is busy.
Call Forward
When Busy
Disable
This code is used to disable call forwarding when the phone is busy.
Do Not Disturb
Enable
This code is used to turn the do not disturb feature on. This has the LTE Device reject all
calls destined to the phone line.
Do Not Disturb
Disable
This code is used to turn the Do Not Disturb feature off.
Table 39 VoIP > SIP > SIP Service Provider > Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
