Chapter 8 Interfaces
NXC Series User’s Guide
131
Each field is explained in the following table.
Table 64 Configuration > Network > Interface > VLAN > Add/Edit
LABEL DESCRIPTION
IPv4/IPv6 View /
IPv4 View / IPv6
View
Use this button to display both IPv4 and IPv6, IPv4-only, or IPv6-only configuration
fields.
Show / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Create New Object Click this button to create a DHCPv6 request object that you may use for the DHCPv6
settings in this screen.
General Settings
Enable Select this to turn this interface on. Clear this to disable this interface.
Interface Properties
Interface Name This field is read-only if you are editing an existing VLAN interface. Enter the number of
the VLAN interface. You can use a number from 0~4094. For example, vlan0, vlan8,
and so on.
VID Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN. Allowed values
are 1 - 4094. (0 and 4095 are reserved.)
Zone Select the zone to which the VLAN interface belongs.
Description Enter a description of this interface. It is not used elsewhere. You can use alphanumeric
and
()+/:=?!*#@$_%- characters, and it can be up to 60 characters long.
Member
Configuration
Use these settings to assign interfaces to this VLAN as members.
Edit Click this to edit the selected interface’s membership values.
# This is sequential indicator of the interface number.
Port Name This indicates the interface name.
Member This indicates whether the selected interface is a member or not of the VLAN which is
currently being edited.
Click this field to edit the value.
Tx Tagging This indicates whether the selected interface tags outbound traffic with this VLAN’s ID .
Click this field to edit the value.
IP Address
Assignment
Get
Automatically
Select this if this interface is a DHCP client. In this case, the DHCP server configures the
IP address, subnet mask, and gateway automatically.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
Subnet Mask This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
Gateway This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The NXC sends packets to the gateway when it
does not know how to route the packet to its destination. The gateway should be on the
same network as the interface.
To Next Page
Loading...
