Chapter 28 System
NXC Series User’s Guide
294
To get the NXC date and time from a time server:
1 Click System > Date/Time.
2 Select Get from Time Server under Time and Date Setup.
3 Under Time Zone Setup, select your Time Zone from the list.
4 Under Time and Date Setup, enter a Time Server Address.
5 Click Apply.
28.5 Console Speed
This section shows you how to set the console port speed when you connect to the NXC via the
console port using a terminal emulation program. See Table 4 on page 20 for default console port
settings.
Click Configuration > System > Console Speed to open this screen.
Figure 169 Configuration > System > Console Speed
The following table describes the labels in this screen.
28.6 DNS Overview
DNS (Domain Name System) is for mapping a domain name to its corresponding IP address and
vice versa. The DNS server is extremely important because without it, you must know the IP
address of a machine before you can access it.
Table 154 Configuration > System > Console Speed
LABEL DESCRIPTION
Console Port Speed Use the drop-down list box to change the speed of the console port. Your NXC supports
9600, 19200, 38400, 57600, and 115200 bps (default) for the console port.
The Console Port Speed applies to a console port connection using terminal emulation
software and NOT the Console in the NXC Web Configurator Status screen.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
