Chapter 28 System
NXC Series User’s Guide
326
28.12.1 Add/Edit Trusted RADIUS Client
Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add
icon or an Edit icon to display the following screen. Use this screen to create a new entry or edit an
existing one.
Figure 194 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
28.13 Language
Click Configuration > System > Language to open this screen. Use this screen to select a
display language for the NXC’s Web Configurator screens.
Table 169 Configuration > System > Auth. Server > Add/Edit
LABEL DESCRIPTION
Activate Select this check box to make this profile active.
Profile Name Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
IP Address Enter the IP address of the RADIUS client that is allowed to exchange messages with the
NXC.
Netmask Enter the subnet mask of the RADIUS client.
Secret Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
NXC and the RADIUS client.
The key is not sent over the network. This key must be the same on the external
authentication server and the NXC.
Description Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
OK Click OK to save the changes.
Cancel Click Cancel to discard the changes.
To Next Page
Loading...
