Chapter 5 Monitor
NXC Series User’s Guide
78
5.12 Radio List
Use this screen to view statistics about the wireless radio transmitters in each of the APs connected
to the NXC. To access this screen, click Monitor > Wireless > AP Information > Radio List.
Figure 36 Monitor > Wireless > AP Information > Radio List
The following table describes the labels in this screen.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to close the window with changes unsaved.
Table 37 Monitor > Wireless > AP Information > AP List > Config AP (continued)
LABEL DESCRIPTION
Table 38 Monitor > Wireless > AP Information > Radio List
LABEL DESCRIPTION
More
Information
Click this to view additional information about the selected radio’s SSID(s), wireless traffic
and wireless clients. Information spans a 24 hour period.
# This is the radio’s index number in this list.
Loading This indicates the AP’s load balance status (UnderLoad or OverLoad) when load
balancing is enabled on the AP. Otherwise, it shows - when load balancing is disabled or
the radio is in monitor mode.
AP Description This displays the description of the AP to which the radio belongs.
Model This displays the model of the AP to which the radio belongs.
MAC Address This displays the MAC address of the radio.
Radio This indicates the radio number on the AP to which it belongs.
OP Mode This indicates the radio’s operating mode. Operating modes are AP (access point), MON
(monitor), Root AP or Repeater.
AP / ZyMesh
Profile
This indicates the AP radio and ZyMesh profile names to which the radio belongs.
Frequency Band This indicates the wireless frequency currently being used by the radio.
This shows - when the radio is in monitor mode.
Channel ID This indicates the radio’s channel ID.
Tx Power This shows the radio’s output power (in dBm).
To Next Page
Loading...
