Chapter 18 AP Profile
NXC Series User’s Guide
228
Figure 128 SSID > MAC Filter List > Add/Edit MAC Filter Profile
The following table describes the labels in this screen.
18.3.4 Layer-2 Isolation List
This screen allows you to create and manage layer-2 isolation profiles that can be used by your
SSIDs. To access this screen click Configuration > Object > AP Profile > SSID > Layer-2
Isolation List.
If a device’s MAC addresses is NOT listed in a layer-2 isolation profile, it is blocked from
communicating with other devices in an SSID on which layer-2 isolation is enabled.
Note: You can have a maximum of 32 layer-2 isolation profiles on the NXC.
Table 116 SSID > MAC Filter List > Add/Edit MAC Filter Profile
LABEL DESCRIPTION
Profile Name Enter up to 31 alphanumeric characters for the profile name. This name is only visible in the
Web Configurator and is only for management purposes. Spaces and underscores are
allowed.
Filter Action Select allow to permit the wireless client with the MAC addresses in this profile to connect to
the network through the associated SSID; select deny to block the wireless clients with the
specified MAC addresses.
Add Click this to add a MAC address to the profile’s list.
Edit Click this to edit the selected MAC address in the profile’s list.
Remove Click this to remove the selected MAC address from the profile’s list.
# This field is a sequential value, and it is not associated with a specific profile.
MAC This field specifies a MAC address associated with this profile.
Description This field displays a description for the MAC address associated with this profile. You can click
the description to make it editable. Enter up to 60 characters, spaces and underscores
allowed.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
