Chapter 16 Firewall
NXC Series User’s Guide
187
16.2 Firewall
The following describes the firewall screen functions.
Click Configuration > Firewall to open the Firewall screen. Use this screen to enable or disable
the firewall and asymmetrical routes, and display the configured firewall rules. Specify from which
zone packets come and to which zone packets travel to display only the rules specific to the
selected direction. Note the following.
• If you enable intra-zone traffic blocking (see the chapter about zones), the firewall automatically
creates (implicit) rules to deny packet passage between the interfaces in the specified zone.
• Besides configuring the firewall, you also need to configure NAT rules to allow computers on the
WAN to access LAN devices.
• The NXC applies NAT (Destination NAT) settings before applying the firewall rules. So for
example, if you configure a NAT entry that sends WAN traffic to a LAN IP address, when you
configure a corresponding firewall rule to allow the traffic, you need to set the LAN IP address as
the destination.
• The ordering of your rules is very important as rules are applied in sequence.
Figure 104 Configuration > Firewall
The following table describes the labels in this screen.
Table 92 Configuration > Firewall
LABEL DESCRIPTION
General Settings
Enable Firewall Select this check box to activate the firewall. The NXC performs access control when the
firewall is activated.
To Next Page
Loading...
