NXC Series User’s Guide
212
CHAPTER 18
AP Profile
18.1 Overview
This chapter shows you how to configure preset profiles for the Access Points (APs) connected to
your NXC’s wireless network.
18.1.1 What You Can Do in this Chapter
•The Radio screen (Section 18.2 on page 213) creates radio configurations that can be used by
the APs.
•The SSID screen (Section 18.3 on page 219) configures three different types of profiles for your
networked APs.
18.1.2 What You Need To Know
The following terms and concepts may help as you read this chapter.
Wireless Profiles
At the heart of all wireless AP configurations on the NXC are profiles. A profile represents a group of
saved settings that you can use across any number of connected APs. You can set up the following
wireless profile types:
• Radio - This profile type defines the properties of an AP’s radio transmitter. You can have a
maximum of 32 radio profiles on the NXC.
• SSID - This profile type defines the properties of a single wireless network signal broadcast by
an AP. Each radio on a single AP can broadcast up to 8 SSIDs. You can have a maximum of 32
SSID profiles on the NXC.
• Security - This profile type defines the security settings used by a single SSID. It controls the
encryption method required for a wireless client to associate itself with the SSID. You can have a
maximum of 32 security profiles on the NXC.
• MAC Filtering - This profile provides an additional layer of security for an SSID, allowing you to
block access or allow access to that SSID based on wireless client MAC addresses. If a client’s
MAC address is on the list, then it is either allowed or denied, depending on how you set up the
MAC Filter profile. You can have a maximum of 32 MAC filtering profiles on the NXC.
• Layer-2 Isolation - This profile can be used to prevent connected wireless clients from
communicating with each other in the NXC’s wireless network(s), on which layer-2 isolation is
enabled, except the devices in the layer-2 isolation list.
To Next Page
Loading...
