Chapter 13 IP/MAC Binding
NXC Series User’s Guide
163
13.2.2 Add/Edit Static DHCP Rule
Click Configuration > Network > IP/MAC Binding > Edit to open this screen. Click the Add or
Edit icon to open the following screen. Use this screen to configure an interface’s IP to MAC address
binding settings.
Figure 86 Configuration > Network > IP/MAC Binding > Edit > Add/Edit
The following table describes the labels in this screen.
13.3 IP/MAC Binding Exempt List
Click Configuration > Network > IP/MAC Binding > Exempt List to open the IP/MAC
Binding Exempt List screen. Use this screen to configure ranges of IP addresses to which the NXC
does not apply IP/MAC binding.
IP Address This is the IP address that the NXC assigns to a device with the entry’s MAC address.
MAC Address This is the MAC address of the device to which the NXC assigns the entry’s IP address.
Description This helps identify the entry.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.
Table 79 Configuration > Network > IP/MAC Binding > Edit (continued)
LABEL DESCRIPTION
Table 80 Configuration > Network > IP/MAC Binding > Edit > Add/Edit
LABEL DESCRIPTION
Interface Name This field displays the name of the interface within the NXC and the interface’s IP address
and subnet mask.
IP Address Enter the IP address that the NXC is to assign to a device with the entry’s MAC address.
MAC Address Enter the MAC address of the device to which the NXC assigns the entry’s IP address.
Description Enter up to 64 printable ASCII characters to help identify the entry. For example, you may
want to list the computer’s owner.
OK Click OK to save your changes back to the NXC.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
