Chapter 28 System
NXC Series User’s Guide
305
28.7.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, TELNET, FTP or SNMP screen to
add a service control rule.
Figure 178 Configuration > System > Service Control Rule > Add/Edit
Admin/User Service
Control
Admin Service Control specifies from which zones an administrator can use HTTP to
manage the NXC (using the Web Configurator). You can also specify the IP addresses
from which the administrators can manage the NXC.
User Service Control specifies from which zones a user can use HTTP to log into the
NXC. You can also specify the IP addresses from which the users can access the NXC.
Add Click this to create a new entry. Select an entry and click Add to create a new entry
after the selected entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s
settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you
take this action.
Move To change an entry’s position in the numbered list, select the method and click Move
to display a field to type a number for where you want to put it and press [ENTER] to
move the rule to the number that you typed.
# This is the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the NXC’s (non-configurable)
default policy. The NXC applies this to traffic that does not match any other configured
rule. It is not an editable rule. To apply other behavior, configure a rule that traffic will
match so the NXC will not have to use the default policy.
Zone This is the zone on the NXC the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
Action This displays whether the computer with the IP address specified above can access
the NXC zone(s) configured in the Zone field (Accept) or not (Deny).
Authentication
Client Authentication
Method
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method screen.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Table 160 Configuration > System > WWW > Service Control (continued)
LABEL DESCRIPTION
To Next Page
Loading...
