Chapter 2 Hardware Installation and Connection
NXC Series User’s Guide
26
2.3 Rear Panel
The NXC2500 rear panel contains a console port, a power switch and a connector for the power
receptacle.
Figure 6 Rear Panel: NXC2500
The NXC5500 rear panel contains a power switch, a connector for the power receptacle and a fan
module.
Figure 7 Rear Panel: NXC5500
Console Port (NXC2500 Only)
Connect this port to your computer (using an RS-232 cable) if you want to configure the NXC using
the command line interface (CLI) via the console port.
For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100 terminal emulation
• 115200 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
SYS Green Off The NXC is not ready or has failed.
On The NXC is ready and running.
Blinking The NXC is booting.
P1~P6
Link
(Left)
Green On This port has a successful link to an Ethernet network
Blinking The NXC is sending or receiving packets to/from an Ethernet network on this
port
Off There is no connection on this port.
P1~P6
Speed
(Right)
Green On This Ethernet connection speed is 100 Mbps on this port.
Orange On This Ethernet connection speed is 1000 Mbps on this port.
Off This Ethernet connection speed is 10 Mbps on this port.
Table 8 Front Panel LEDs: NXC5500 (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
