Chapter 28 System
NXC Series User’s Guide
322
28.11.3 Configuring SNMP
Your NXC can act as an SNMP agent, which allows a manager station to manage and monitor the
NXC through the network.
To change your NXC’s SNMP settings, click Configuration > System > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings, including from which zones
SNMP can be used to access the NXC. You can also specify from which IP addresses the access can
come and configure user profiles that define allowed SNMPv3 access.
Figure 191 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 166 Configuration > System > SNMP
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the
IP address(es) in the Service Control table to access the NXC using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Trap
To Next Page
Loading...
