Chapter 28 System
NXC Series User’s Guide
325
Figure 193 Configuration > System > Auth. Server
The following table describes the labels in this screen.
Table 168 Configuration > System > Auth. Server
LABEL DESCRIPTION
Enable Select the check box to have the NXC act as a RADIUS server.
Authentication
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the NXC to
the RADIUS client. You must have certificates already configured in the My Certificates
screen.
Authentication
Method
Select an authentication method if you have created any in the Configuration > Object >
Auth. Method screen.
Service Control This specifies from which computers you can access which NXC zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it
before doing so. Note that subsequent entries move up by one when you take this action.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This is the index number of the entry.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Profile Name This field indicates the name assigned to the profile.
IP Address This is the IP address of the RADIUS client that is allowed to exchange messages with the
NXC.
Mask This is the subnet mask of the RADIUS client.
Description This is the description of the RADIUS client.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
